THE AT-HOME SUPPER CLUB

DIY Place Cards with Ribbon

Make DIY place cards with ribbon: choose a card and a tie, attach a bow or tag holder, write clear names, and set each card at its place without fuss.

3 min read0 viewsDIY Place Cards with Ribbon
— · 0 votes
Contents
  1. Choosing card stock and ribbon
  2. Ways to attach ribbon to a card
  3. Writing names and setting the places
  4. Questions About Ribbon Place Cards
  5. Do I need a hole punch to make ribbon place cards?
  6. What ribbon width works for a small place card?
  7. Can I reuse DIY place cards at another gathering?
  8. How do I keep a ribbon bow from coming undone on a place card?

DIY place cards with ribbon are small name cards you make yourself and fasten to a napkin, a glass, or a favor with a ribbon tie. The ribbon holds the card upright and marks the seat, while the card carries the name. You need a card, a length of ribbon, a way to join them, and a pen that does not smudge. The work is quiet and quick, and you can finish it at the table the day before.

Choosing card stock and ribbon

Card stock is the base of a DIY place card, so pick a weight that stands without bending at the top. A heavier sheet holds a fold and takes ink without bleeding through to the back. Ribbon should be narrow enough to pass through a small hole or around a rolled napkin edge. Satin ribbon slides loose easily, so a matte or grosgrain ribbon grips the knot better.

Ways to attach ribbon to a card

A tag holder is a small folded card with a slot or a hole, and it lets you swap names without unpicking the ribbon. For a flat card, punch a single hole near one edge and thread the ribbon through before tying. A bow decoration can sit at the front of the card or be tied around a folded napkin with the card slipped underneath. Fabric place cards take a stitched ribbon tab well and stay soft at the edge of a plate.

Writing names and setting the places

Write names in block letters large enough to read from across the table, and leave the back of the card blank. Check the spelling of each name against your guest list before you tie anything. Set finished cards out in seating order so each one lands at the right cover. Store them flat and stacked lightly, because a pressed bow flattens and a folded card takes a crease.

Questions About Ribbon Place Cards

Do I need a hole punch to make ribbon place cards?

No, a hole punch is not required for ribbon place cards, though it makes a neat opening. You can tie the ribbon around a folded card, a napkin, or a tag holder with a slot already cut. A small awl or a sturdy needle can open a hole in card stock when a punch is not at hand.

What ribbon width works for a small place card?

Narrow ribbon suits a small place card because it does not overwhelm the card face. A width that fits through your chosen hole or slot keeps the tie simple. Test a short length first, since a ribbon too wide for the card edge will hang loose.

Can I reuse DIY place cards at another gathering?

Yes, DIY place cards can be reused when the name is not written directly on the card. A tag holder with a slip of paper lets you replace the name and keep the ribbon tie. Cards written in ink are fixed to one name, so plan for fresh cards at the next table.

How do I keep a ribbon bow from coming undone on a place card?

A ribbon bow stays tied on a place card when you trim the ends and pull the knot firm against the card. A dab of fabric glue on the knot holds the loops in place without stiffening the whole ribbon. Check each bow once the card is set, since a loose bow slides down the ribbon.

Latest articles