How to Tie a Ribbon Bow on a Christmas Tree
Learn how to tie a ribbon bow on a Christmas tree with wired ribbon, even loops and full tails. A clear step-by-step tutorial for a tree topper bow and lower branches.
Contents
- Choosing wired ribbon for the tree
- Folding even loops and tails
- Fixing the bow to a branch
- Questions about tree ribbon bows
- Do I need a ribbon bow tutorial for a Christmas tree if I have never tied one?
- Can I use plain ribbon instead of wired ribbon?
- How do I make a tree topper bow that stays upright?
- Where should the tails of the bow hang on the tree?
Tying a ribbon bow on a Christmas tree means folding the ribbon into even loops, cinching the center tightly and fluffing the loops so the bow holds its shape. Wired ribbon helps, because the wire inside the edges lets the loops and tails stay where you place them. The same method works for a large tree topper bow or for smaller bows on lower branches. This page walks through one ribbon bow tutorial for a Christmas tree, from cutting the ribbon to fixing the bow in place.
Choosing wired ribbon for the tree
Wired ribbon holds a bow shape far better than plain ribbon, because a thin wire runs along each edge. Choose decorative ribbon wide enough to look right against the size of the tree, and allow generous extra length for loops and tails. A ribbon with a firm body and a thin wire edge bends without creasing and keeps its width in the loop. Cut the ribbon with sharp shears so the ends stay clean before you fold.
Folding even loops and tails
A balanced Christmas tree decoration bow begins with a center point marked by pinching the ribbon between your fingers. Fold one side into a loop and grip it at the pinch, then fold the other side into a matching loop of the same size. Leave a long tail hanging below each loop, so the bow has bow loops and tails that read clearly from a distance. Keep the loops open rather than flat, since open loops give the finished bow its shape.
Fixing the bow to a branch
After you cinch the center with a twist of florist wire, the bow stays locked while you fluff each loop outward and arrange the tails. Attach the bow to the tree with the wire ends twisted around a sturdy branch near the trunk, so the weight of the bow does not pull the branch down. For a tree topper bow, bind the center wire to the top spike or the highest trunk point instead of a side branch. Step back and adjust any loop that blocks light from the tree lights.
Questions about tree ribbon bows
Do I need a ribbon bow tutorial for a Christmas tree if I have never tied one?
Yes, a short ribbon bow tutorial for a Christmas tree helps even a first attempt, because the order of steps matters more than the ribbon itself. Pinching the center before you fold keeps both loops even, and a wire tie at the middle prevents the bow from slipping. Practicing once on a spare length of ribbon shows you how much tail to leave.
Can I use plain ribbon instead of wired ribbon?
Plain ribbon can make a Christmas tree bow, but it tends to sag and lose its loop shape over time. Wired ribbon keeps the loops and tails upright without extra support, which matters on a tree where gravity works against the bow. If you use plain decorative ribbon, tie tighter loops and expect to reshape the bow after handling.
How do I make a tree topper bow that stays upright?
A tree topper bow stays upright when its center is bound tightly to the top spike or the highest point of the trunk. Build the bow with loops that face outward and tails that fall down the side of the tree. Twist the binding wire around the spike several times, then fluff the loops once the bow is fixed.
Where should the tails of the bow hang on the tree?
The tails of a Christmas tree bow should hang straight down and be trimmed to a length that suits the branch. Cut each tail at an angle or into a notch so the end looks finished and does not fray. Keep the tails clear of lights and heat sources on the tree.