How to Sharpen a Bar Knife
Learn bar knife sharpening on a whetstone, how to find the right angle for a KA-BAR knife, and why a dull blade sometimes refuses to get sharp.
Contents
- Sharpening steps on a whetstone
- Matching the angle on a KA-BAR knife
- When the knife is not sharpening
- Questions about sharpening bar knives
- Is a sharpening bar the same as a whetstone?
- How often should a bar knife be sharpened?
- Can you sharpen a serrated bar knife on a whetstone?
- How do you test whether a knife is sharp after sharpening?
To sharpen a bar knife, grind both sides of the edge on a whetstone at a steady angle. Work from a coarse stone to a fine one until a small burr forms along the edge. Finish with light honing strokes to straighten the edge before the knife returns to the bar. The steps below cover choosing the angle, sharpening a KA-BAR knife and fixing an edge that stays dull.
Sharpening steps on a whetstone
Sharpening a bar knife on a whetstone starts with soaking or oiling the stone as its maker directs. Set the stone on a damp towel or holder so it cannot slide during the strokes. Stroke the edge across the coarse side until a burr, a thin curl of metal, forms underneath. Repeat on the second side, then switch to the fine grit with lighter strokes.
Matching the angle on a KA-BAR knife
The sharpening angle for a KA-BAR knife should match the bevel ground on the blade at the factory. Color the bevel, the slanted strip along the edge, with a marker before the first stroke. If the stone removes ink evenly from heel to tip, your angle matches the original grind. Thin bar knives typically take 15 to 20 degrees per side, while sturdy utility blades need wider angles.
When the knife is not sharpening
A knife that is not sharpening has usually not yet raised a burr along the whole edge. Without that thin lip of metal on the far side, the two bevels have not met. Wobbling the angle between strokes rounds the edge instead of grinding it to a point. A clogged or dished stone also cuts poorly and needs cleaning or flattening before more work.
Questions about sharpening bar knives
Is a sharpening bar the same as a whetstone?
No, a sharpening bar, also called a honing steel, mainly realigns an edge rather than removing much metal. Edge honing straightens a thin edge that has rolled from cutting citrus peel and garnishes. A whetstone is needed once honing no longer brings back a clean cut.
How often should a bar knife be sharpened?
A bar knife needs sharpening when honing stops restoring its bite on citrus skin. The interval depends on how much fruit you cut, the board surface and the steel. Cutting on wooden or soft plastic boards dulls a blade more slowly than glass or stone.
Can you sharpen a serrated bar knife on a whetstone?
No, a flat whetstone cannot reach into the scallops of a serrated bar knife. Serrated edges need a tapered rod that fits each scallop on the beveled side only. A professional knife sharpener can restore blades with chipped or badly worn serrations.
How do you test whether a knife is sharp after sharpening?
A sharp knife slices cleanly through a sheet of paper held loosely by one corner. A dull blade snags, tears or skids across the paper instead of cutting it. Keep the edge moving away from the hand that holds the sheet.