How to Replace LED Bulbs
A plain guide to swapping an LED bulb: cutting the power, matching the base and shape, seating it in the socket, and checking the fixture.
Contents
- Cut the power before you touch anything
- Match the base and the bulb shape
- Seat the new bulb in the socket
- Questions about replacing LED bulbs
- How do I install LED bulbs in a fixture that already has one?
- Can I replace an ordinary light bulb with an LED bulb?
- What should I do if the new bulb does not light?
- Do I need to turn off the power to change a bulb?
Replacing an LED bulb means cutting power at the switch, matching the new bulb to the old base and voltage, and seating it firmly in the light bulb socket without overtightening. The steps below cover how to replace LED bulbs on lamps, string lights and decorative fixtures, and how to install LED bulbs that fit the holder you already have. A few checks before you start keep the job quick and safe.
Cut the power before you touch anything
Turning off the switch is the first step, and unplugging a lamp or string light is safer still. Power off before replacing any bulb, even one that looks cold and dead. Let a bulb that has been lit cool down before your fingers go near the glass. If a fixture is wired into the wall and the switch does not clearly cut it, a trained electrician should handle it.
Match the base and the bulb shape
A replacement bulb has to fit the socket, so check the base size and thread before you buy. Bulb base sizes are printed on the old bulb or the socket, and LED bulb types range from small candle shapes to large globes. Take the old bulb with you when you shop, or note the code on its base. A bulb of the right base but the wrong shape may not fit under a shade or inside a decorative holder.
Seat the new bulb in the socket
Screw or push the new bulb in by hand until it sits snug, then stop before you force it. Overtightening can crack the glass or bend the contact inside the light bulb socket. For pin-based bulbs, line up the pins and press straight in without twisting. Switch the power back on and check that the bulb lights before you refit any shade or cover.
Questions about replacing LED bulbs
How do I install LED bulbs in a fixture that already has one?
Installing an LED bulb in a fixture follows the same steps as replacing one: cut the power, let the old bulb cool, and unscrew or unclip it. Match the new bulb to the base and voltage shown on the old one, then seat it by hand. Check that the fixture is rated for the bulb you chose before you switch it on.
Can I replace an ordinary light bulb with an LED bulb?
Yes, an ordinary bulb can often be replaced with an LED bulb when the base and voltage match and the fixture accepts the bulb shape. Check the label inside the fixture for its rating, because some dimmers and enclosed fittings need a compatible replacement bulb. An LED bulb made for a dimmer carries that marking on its packaging.
What should I do if the new bulb does not light?
A new bulb that stays dark may be loose, so switch off the power and reseat it in the socket. Check that the power is actually reaching the fixture and that the switch is on. If a second bulb of the same type also fails, the fault is likely in the fixture and a trained electrician should look at it.
Do I need to turn off the power to change a bulb?
Yes, power off before replacing any bulb, even an LED that runs cool. Switching off and unplugging removes the risk of a shock if your fingers touch the contacts inside the socket. On a string light, unplug the whole set rather than relying on a small inline switch.