How to Clean Beer Lines in a Pub
A plain guide to cleaning beer lines in a pub: the steps for a bar draught system, how often to do it, and who should handle commercial line cleaning.
Contents
- Gather the line cleaning supplies
- Run the solution through each line
- Reconnect and check the pour
- Questions about pub beer line cleaning
- How often should beer lines be cleaned in a pub?
- Can bar staff clean the lines themselves?
- What happens if you skip line cleaning?
- Do you need to rinse beer lines after cleaning?
Cleaning beer lines in a pub means flushing every draught line from keg coupler to tap with a cleaning solution, then rinsing it fully before beer flows again. The job protects the taste of the beer and the condition of the bar draught system. This page sets out the steps, how cleaning frequency for pubs is decided, and where a trained specialist belongs.
Gather the line cleaning supplies
A line cleaning kit for a pub holds a cleaning chemical made for beer lines, a pump or pressure pot, a coupling that fits the keg coupler, and a tap spigot brush. You also need clean water for rinsing and a container to catch the solution that comes out of the taps. Check the chemical label for the dilution it expects and mix it in the vessel the kit provides. Keep the chemical away from glasses and food surfaces while it is in use.
Run the solution through each line
Commercial line cleaning starts by shutting off the gas and removing every keg coupler from its line. Fit the cleaning coupling to the first line and pump the solution through until it runs clear at the tap. Let the solution sit in the line for the time the chemical maker states, then push it out with clean water. Repeat for each line, and finish by flushing with water until no chemical remains.
Reconnect and check the pour
After cleaning, reconnect each coupler and open the gas slowly. Pour a small glass from every tap and look at the flow and the foam before serving anyone. A line that still tastes of chemical or pours flat needs another rinse or a check of the gas setting. Record the date on a cleaning log so the next session is easy to schedule. A bar staff procedure for weekly cleaning keeps the steps the same each time.
Questions about pub beer line cleaning
How often should beer lines be cleaned in a pub?
Beer lines in a pub are cleaned on a set schedule that fits how much beer each line pours and what the chemical maker and brewer advise. A line that pours slowly can go longer between cleans than a busy tap. Write the interval into your cleaning log and follow it, rather than waiting for a taste problem to appear.
Can bar staff clean the lines themselves?
Bar staff can clean beer lines when they are trained on the kit and the chemical in use. The work involves pressure, caustic cleaners and gas, so a person who has not been shown the procedure should not attempt it. Where the system is complex or the chemical is hazardous, a trained specialist should do the job.
What happens if you skip line cleaning?
Skipped line cleaning lets yeast, bacteria and beer stone build up inside the tube of the draught system. The beer then picks up off flavors and pours with poor foam, and the line can clog over time. A regular clean protects the taste and keeps the system working.
Do you need to rinse beer lines after cleaning?
Beer lines are always rinsed with clean water after the cleaning solution has done its work. Rinsing pushes out the chemical so the first beer through the tap is not tainted. Flush until the water runs clear, then reconnect the keg and pour a test glass.