# Fix a Wobbly RV Table

Learn how to trace the wobble in an RV dinette table and tighten or re-seat the pedestal base, floor mount and mounting bracket safely.

A wobbly RV table is fixed by finding where the movement starts, then tightening or re-seating that joint. The play almost always comes from one of three places on a dinette table: the tabletop screws, the mounting bracket under the top, or the pedestal base where it meets the floor. Work through them from the top down and the table settles again. 

## Trace the wobble to its joint 

A wobbly RV table tells you where it moves if you watch the joints while a helper rocks the top gently. Grip the tabletop edge and shift it side to side, then front to back, and note which part stays still. Loose screws at the mounting bracket show as a top that rocks while the pedestal stays firm. Movement at the floor mount shows as the whole pedestal leaning with the top. 

## Tighten the tabletop and bracket 

Screws holding the tabletop to its mounting bracket loosen as a motorhome table flexes on the road. Turn each screw snug with the correct driver, then stop before the point where the wood or composite starts to crush. A screw that spins without gripping needs a slightly wider screw or a filled and redrilled hole. Check the bracket itself for a bent flange, because a distorted bracket keeps working loose. 

## Stabilize the pedestal and floor mount 

A pedestal base that rocks at the floor needs its fasteners checked and its foot re-seated against the surface. Reach under the floor mount and confirm each bolt or screw is tight, adding a washer where the fastener has pulled through. If the floor material around the mount has softened, a trained RV technician should assess the repair before you drive. Never drill into a floor without knowing what runs beneath it. 

## Questions About RV Table Stability 

### What causes a wobbly RV dinette table? 

A wobbly RV dinette table comes from play in a joint, not from the tabletop itself. Loose screws at the mounting bracket let the top rock, while a loose pedestal base lets the whole column lean. Wear in the floor mount or a softened floor panel adds movement that tightening alone will not remove. 

### Can I fix a wobbly RV table myself? 

Yes, a wobbly RV table with loose fasteners is a job you can do yourself with a screwdriver, a wrench and a helper to rock the top. Tightening screws and re-seating a bracket need no special tools. Any repair to the floor structure or the vehicle frame calls for a trained technician. 

### Why does my motorhome table loosen again after tightening? 

A motorhome table loosens again when the fastener has lost its grip in the wood or the bracket is bent. A screw turning freely in a worn hole will not hold, so fill the hole and refit a slightly wider screw. Check the bracket for distortion, since a bent part keeps flexing and working the screws out. 

### Should I add support to a pedestal base? 

Support added to a pedestal base helps only after the existing fasteners are tight and the foot sits flat on the floor. A washer under a pulled fastener spreads the load and reduces movement at the floor mount. Do not add bracing that blocks the table from folding or that covers the base fasteners you need to reach.
