Bunting Length Calculator: How Much Bunting to Buy for a Party
Work out how much bunting a party needs from the run you are decorating and the flag spacing you want, with a simple formula for string length.
Contents
- Measure the run you will decorate
- Decide the gap between flags
- Turn the run into length and flag count
- Questions about bunting length estimates
- How does a bunting length calculator work?
- How do I work out the flag count for a string of pennants?
- What gap should I leave between flags?
- Does swag or draping change the party banner length?
A bunting length calculator helps you decide how much bunting to buy by turning the run you plan to decorate into a string length and a flag count. You measure the wall, fence or doorway, choose the gap you want between flags, and add a little extra for draping and for tying the ends. The method below keeps the estimate simple enough to do on paper before you order.
Measure the run you will decorate
Start by measuring the wall or fence for bunting along the line where the string will hang, not along the floor. A tape measure along the fixing points gives the true run, and a doorway or gate needs the width plus the height of both tie points. Write the figure down in one unit so the rest of the sum stays consistent.
Decide the gap between flags
Flag spacing sets how full the bunting looks, because a tight string of pennants reads as a solid band while a wide gap looks airy. A gap roughly equal to the flag width gives an even, layered look, and a wider gap suits a long fence where a dense string would be costly. The same run therefore needs more flags at a small gap and fewer at a large one.
Turn the run into length and flag count
Divide the measured run by the flag width plus the gap you chose, and the result is the flag count for one straight span. Multiply that flag count by the flag width plus the gap again to get the string length, then add extra for any swag or tie-off. Bunting bought by the meter or by the flag count follows the same formula.
Questions about bunting length estimates
How does a bunting length calculator work?
A bunting length calculator divides the run you are decorating by the flag width plus the gap between flags to give a flag count. It then multiplies that count back by the same spacing to give the string length. Add extra length for swags, corners and tying the ends to a rail or post.
How do I work out the flag count for a string of pennants?
The flag count for a string of pennants comes from the run divided by the flag width plus the gap you want. Round up to a whole flag so the spacing stays even along the run. A long fence needs fewer flags when the gap is wide and more when the gap is narrow.
What gap should I leave between flags?
The gap between flags depends on the look you want and the width of each flag. A gap close to the flag width gives a full, layered garland, while a wider gap stretches the same flags over a longer span. Measure one flag first, then set the gap from that width.
Does swag or draping change the party banner length?
Swag or draping changes the party banner length because a hanging string follows a longer path than a straight line. Add extra length for each dip between fixing points, and add a short tail at each end for tying. The deeper the swag, the more extra length the string needs.